Webing Slinging Safety Training

1. Regulations & Compliance

• Follows OSHA 1910.184 (Slings) and ANSI/ASME B30.9 (Slings) regulations for safe lifting and material handling.

• Operators must be trained and certified in webbing sling inspection, proper usage, and safe lifting practices.

2. Pre-Operation Safety Checks

• Inspect the Sling: Before each use, inspect the webbing sling for cuts, fraying, and signs of wear, corrosion, or damage. Discard any sling that shows signs of damage or degradation.

• Check Load Capacity: Ensure the webbing sling is rated for the weight of the load being lifted. Never exceed the working load limit (WLL) marked on the sling.

• Proper Attachment: Verify that the sling is properly attached to both the load and the lifting hook or equipment to ensure stability.

3. Safe Slinging and Lifting Procedures

• Choose the Correct Sling: Select the right type and size of webbing sling based on the load’s weight, shape, and lifting method (vertical, basket, or choker hitch).

• Load Balance: Ensure that the load is balanced and stable before lifting. Improperly balanced loads can shift, causing the sling to snap or the load to tip.

• Safe Lifting Techniques: Lift the load slowly and steadily to prevent sudden jerks that could damage the webbing sling or cause instability in the load.

• Communication: Use clear communication methods, such as hand signals or radios, to coordinate with the crane operator or team members during the lift.

4. Common Hazards & Prevention

• Overloading: Never exceed the rated capacity of the webbing sling. Always ensure the sling is rated for the load being lifted to avoid breakage or accidents.

• Wear and Tear: Webbing slings can wear down over time, especially with rough handling or exposure to harsh conditions. Ensure they are inspected regularly and replaced if needed.

• Pinch Points: Be aware of pinch points between the load, the sling, and the lifting equipment. Keep hands and body parts clear of these areas during lifting.

• Improper Slinging: Always ensure that slings are applied correctly. Incorrect sling configuration can lead to slippage, damage, or an unstable lift.

5. Emergency Procedures

• Slippage or Failure: If the sling or load begins to slip, immediately stop the lift, lower the load to the ground, and reconfigure the sling before attempting another lift.

• Injury Response: In case of injury, provide first aid and call for emergency services if needed. Ensure the injured worker is moved to a safe area.

• Equipment Malfunction: If any lifting equipment fails, stop the operation immediately, secure the load, and notify a supervisor for inspection and repair.

6. Certification & Refresher Training

• Initial Certification: Includes training on sling inspection, safe lifting techniques, hazard identification, and emergency procedures.

• Refresher Training: Recommended every 1-2 years or after an incident to ensure operators are familiar with updated safety procedures and equipment standards.